The Fastback 11 binding machine by Powis Parker is an innovative and intelligently-designed thermal binding machine. From time to time, even the best binding machines will experience minor jams, so taking the time to learn the basic steps for clearing a jam will not only save you time, but will also prevent you from damaging your machine. Below are the instructions for clearing a jammed Fastback binding strip from your Fastback 11 binder:
- Begin by putting on the Heat Protective Glove that comes in the Accessory Pack included with every Fastback 11 binding machine. Because the inner workings of the machine are extremely hot, wearing the glove will help to protect you.
- Turn the Fastback 11 off and unplug it. Allow the machine to cool for approximately 15 to 20 minutes.
- If you have chosen to install the Cooling Rack on top of the machine, remove it and set it aside.
- To open the machine, gently push the eraser end of a pencil through the hole in the lower right corner of the machine until the cover pops open slightly. Next, carefully push the cover open until it stops in the upright position.
- Remove the jammed binding strip using the Wire Tongs included in your Accessory Pack. If you cannot easily reach the jammed strip with the Wire Tongs, lifting the blue metal bookrest may make it easier to access.
- After removing the jammed Fastback strip, press the bookrest back into its original position, until it clicks and locks into place.
- Close the machine by gently pressing down on both sides of the cover until the latch clicks and locks in position.